|
IWORKFORTHEMAN:MAN
|
|
Join Date: Dec 2005
Location: yes
|
|
Sep 3rd, 2007, 04:30 AM
TIP#3
THE SCARY HOMELESS RAPIST THAT LIVES IN YOUR TRASHCAN.(COMMONLY KNOWN AS TRASHCAN TRAUMA)
YOU'LL NEED
ONE PLASTIC TRASHCAN LIKE THIS:
( I WILL ASSUME YOUR TRASHCAN IS GOING TO BE ATLEAST 4 FEET)
1 2 FT LONG 1/2" PVC PIPE,
1 3 FT LONG 1" PVC PIPE,
2 1" PVC CAPS
1 3/4" PVC CAP
A 1/2" to 3/4" PVC ADAPTER
SOME RUBBER HOSE
A 1" PVC BARB FITTING
A AIR COMPRESSOR
A FOAM HEAD AND MASK.
SOME PVC GLUE
First of all, make shure your pipes fit like this here:
Drill a hole into the bottom of a 1" cap, to fit the barb fitting.
Good, now cap the bottom of the 3/8 pipe with the 1" cap, like so:
Now, take your 1/2 pipe and cut it if it plus the 1" pipe is taller than your trashcan, when done,
put the adapter at one end of the pipe, and put the 3/4 cap onto the adapter. Then slide it down
the 1" pipe.
If it slides down and you can barley see any spaces between the 1" pipe and the cap inside, then
continue.
Now, take your your other 1" cap and drill a hole into it so that the 1/2" pipe can slider down it nice and easy.
Then, put the 1/2" pipe with the adapter and 3/5 cap on and slide it down the 1" pipe, then take the 1" cap with the hole drilled in it and add it to the top.
Good, now take the barb attachment and glue it into the hole of the bottom cap, then put on the rubber hose onto the cap. Attach it to your compressor and test it out.
Okay, now take your new pnuematic pipe and attach mount it to the bottom of the trashcan, Then drill a hole in the side and run the tube through.
Then fit the foam head over the 1/2 pipes top, put the mask on it.
Test it out a bit, then, if you want add a lid to the head of the mask.
Test it out a bit, the head should pop out of the trashcan,
CONGRATULATIONS YOU MADE THIS.
|
__________________
|
|
|